.\" (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF
.\" THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
.\"
-.\" $OpenBSD: sshd_config.5,v 1.52 2006/02/24 23:43:57 jmc Exp $
+.\" $OpenBSD: sshd_config.5,v 1.53 2006/02/24 23:51:17 jmc Exp $
.Dd September 25, 1999
.Dt SSHD_CONFIG 5
.Os
.It Pa /etc/ssh/sshd_config
.El
.Sh DESCRIPTION
-.Nm sshd
+.Xr sshd 8
reads configuration data from
.Pa /etc/ssh/sshd_config
(or the file specified with
The default is not to accept any environment variables.
.It Cm AddressFamily
Specifies which address family should be used by
-.Nm sshd .
+.Xr sshd 8 .
Valid arguments are
.Dq any ,
.Dq inet
The default is 120 seconds.
.It Cm LogLevel
Gives the verbosity level that is used when logging messages from
-.Nm sshd .
+.Xr sshd 8 .
The possible values are:
QUIET, FATAL, ERROR, INFO, VERBOSE, DEBUG, DEBUG1, DEBUG2, and DEBUG3.
The default is INFO.
the three colon separated values
.Dq start:rate:full
(e.g. "10:30:60").
-.Nm sshd
+.Xr sshd 8
will refuse connection attempts with a probability of
.Dq rate/100
(30%)
.Ev LD_PRELOAD .
.It Cm PidFile
Specifies the file that contains the process ID of the
-.Nm sshd
-daemon.
+SSH daemon.
The default is
.Pa /var/run/sshd.pid .
.It Cm Port
Note that this option applies to protocol version 2 only.
.It Cm SyslogFacility
Gives the facility code that is used when logging messages from
-.Nm sshd .
+.Xr sshd 8 .
The possible values are: DAEMON, USER, AUTH, LOCAL0, LOCAL1, LOCAL2,
LOCAL3, LOCAL4, LOCAL5, LOCAL6, LOCAL7.
The default is AUTH.
.Pa /usr/X11R6/bin/xauth .
.El
.Ss Time Formats
-.Nm sshd
+.Xr sshd 8
command-line arguments and configuration file options that specify time
may be expressed using a sequence of the form:
.Sm off
.Bl -tag -width Ds
.It Pa /etc/ssh/sshd_config
Contains configuration data for
-.Nm sshd .
+.Xr sshd 8 .
This file should be writable by root only, but it is recommended
(though not necessary) that it be world-readable.
.El