/*
-
-packet.h
-
-Author: Tatu Ylonen <ylo@cs.hut.fi>
-
-Copyright (c) 1995 Tatu Ylonen <ylo@cs.hut.fi>, Espoo, Finland
- All rights reserved
-
-Created: Sat Mar 18 02:02:14 1995 ylo
-
-Interface for the packet protocol functions.
-
-*/
-
-/* RCSID("$Id$"); */
+ * Author: Tatu Ylonen <ylo@cs.hut.fi>
+ * Copyright (c) 1995 Tatu Ylonen <ylo@cs.hut.fi>, Espoo, Finland
+ * All rights reserved
+ * Interface for the packet protocol functions.
+ *
+ * As far as I am concerned, the code I have written for this software
+ * can be used freely for any purpose. Any derived versions of this
+ * software must be clearly marked as such, and if the derived work is
+ * incompatible with the protocol description in the RFC file, it must be
+ * called by a name other than "ssh" or "Secure Shell".
+ */
+
+/* RCSID("$OpenBSD: packet.h,v 1.25 2001/06/26 17:27:24 markus Exp $"); */
#ifndef PACKET_H
#define PACKET_H
-#include "config.h"
-
-#ifdef HAVE_OPENSSL
#include <openssl/bn.h>
-#endif
-#ifdef HAVE_SSL
-#include <ssl/bn.h>
-#endif
-
-/* Sets the socket used for communication. Disables encryption until
- packet_set_encryption_key is called. It is permissible that fd_in
- and fd_out are the same descriptor; in that case it is assumed to
- be a socket. */
-void packet_set_connection(int fd_in, int fd_out);
-
-/* Puts the connection file descriptors into non-blocking mode. */
-void packet_set_nonblocking(void);
-
-/* Returns the file descriptor used for input. */
-int packet_get_connection_in(void);
-
-/* Returns the file descriptor used for output. */
-int packet_get_connection_out(void);
-
-/* Closes the connection (both descriptors) and clears and frees
- internal data structures. */
-void packet_close(void);
-
-/* Causes any further packets to be encrypted using the given key. The same
- key is used for both sending and reception. However, both directions
- are encrypted independently of each other. Cipher types are
- defined in ssh.h. */
-void packet_set_encryption_key(const unsigned char *key, unsigned int keylen,
- int cipher_type, int is_client);
-
-/* Sets remote side protocol flags for the current connection. This can
- be called at any time. */
-void packet_set_protocol_flags(unsigned int flags);
-
-/* Returns the remote protocol flags set earlier by the above function. */
-unsigned int packet_get_protocol_flags(void);
-
-/* Enables compression in both directions starting from the next packet. */
-void packet_start_compression(int level);
-
-/* Informs that the current session is interactive. Sets IP flags for optimal
- performance in interactive use. */
-void packet_set_interactive(int interactive, int keepalives);
-
-/* Returns true if the current connection is interactive. */
-int packet_is_interactive(void);
-
-/* Starts constructing a packet to send. */
-void packet_start(int type);
-
-/* Appends a character to the packet data. */
-void packet_put_char(int ch);
-
-/* Appends an integer to the packet data. */
-void packet_put_int(unsigned int value);
-/* Appends an arbitrary precision integer to packet data. */
-void packet_put_bignum(BIGNUM *value);
-
-/* Appends a string to packet data. */
-void packet_put_string(const char *buf, unsigned int len);
-
-/* Finalizes and sends the packet. If the encryption key has been set,
- encrypts the packet before sending. */
-void packet_send(void);
-
-/* Waits until a packet has been received, and returns its type. */
-int packet_read(int *payload_len_ptr);
-
-/* Waits until a packet has been received, verifies that its type matches
- that given, and gives a fatal error and exits if there is a mismatch. */
-void packet_read_expect(int *payload_len_ptr, int type);
-
-/* Checks if a full packet is available in the data received so far via
- packet_process_incoming. If so, reads the packet; otherwise returns
- SSH_MSG_NONE. This does not wait for data from the connection.
-
- SSH_MSG_DISCONNECT is handled specially here. Also,
- SSH_MSG_IGNORE messages are skipped by this function and are never returned
- to higher levels. */
-int packet_read_poll(int *packet_len_ptr);
-
-/* Buffers the given amount of input characters. This is intended to be
- used together with packet_read_poll. */
-void packet_process_incoming(const char *buf, unsigned int len);
-
-/* Returns a character (0-255) from the packet data. */
-unsigned int packet_get_char(void);
-
-/* Returns an integer from the packet data. */
-unsigned int packet_get_int(void);
-
-/* Returns an arbitrary precision integer from the packet data. The integer
- must have been initialized before this call. */
-void packet_get_bignum(BIGNUM *value, int *length_ptr);
-
-/* Returns a string from the packet data. The string is allocated using
- xmalloc; it is the responsibility of the calling program to free it when
- no longer needed. The length_ptr argument may be NULL, or point to an
- integer into which the length of the string is stored. */
-char *packet_get_string(unsigned int *length_ptr);
-
-/* Logs the error in syslog using LOG_INFO, constructs and sends a disconnect
- packet, closes the connection, and exits. This function never returns.
- The error message should not contain a newline. The total length of the
- message must not exceed 1024 bytes. */
-void packet_disconnect(const char *fmt, ...);
-
-/* Sends a diagnostic message to the other side. This message
- can be sent at any time (but not while constructing another message).
- The message is printed immediately, but only if the client is being
- executed in verbose mode. These messages are primarily intended to
- ease debugging authentication problems. The total length of the message
- must not exceed 1024 bytes. This will automatically call
- packet_write_wait. If the remote side protocol flags do not indicate
- that it supports SSH_MSG_DEBUG, this will do nothing. */
-void packet_send_debug(const char *fmt, ...);
-
-/* Checks if there is any buffered output, and tries to write some of the
- output. */
-void packet_write_poll(void);
-
-/* Waits until all pending output data has been written. */
-void packet_write_wait(void);
-
-/* Returns true if there is buffered data to write to the connection. */
-int packet_have_data_to_write(void);
-
-/* Returns true if there is not too much data to write to the connection. */
-int packet_not_very_much_data_to_write(void);
-
-/* Stores tty modes from the fd into current packet. */
-void tty_make_modes(int fd);
-
-/* Parses tty modes for the fd from the current packet. */
-void tty_parse_modes(int fd, int *n_bytes_ptr);
+void packet_set_connection(int, int);
+void packet_set_nonblocking(void);
+int packet_get_connection_in(void);
+int packet_get_connection_out(void);
+void packet_close(void);
+void packet_set_encryption_key(const u_char *, u_int, int);
+void packet_set_protocol_flags(u_int);
+u_int packet_get_protocol_flags(void);
+void packet_start_compression(int);
+void packet_set_interactive(int);
+int packet_is_interactive(void);
+
+void packet_start(u_char);
+void packet_put_char(int ch);
+void packet_put_int(u_int value);
+void packet_put_bignum(BIGNUM * value);
+void packet_put_bignum2(BIGNUM * value);
+void packet_put_string(const char *buf, u_int len);
+void packet_put_cstring(const char *str);
+void packet_put_raw(const char *buf, u_int len);
+void packet_send(void);
+
+int packet_read(int *payload_len_ptr);
+void packet_read_expect(int *payload_len_ptr, int type);
+int packet_read_poll(int *packet_len_ptr);
+void packet_process_incoming(const char *buf, u_int len);
+
+u_int packet_get_char(void);
+u_int packet_get_int(void);
+void packet_get_bignum(BIGNUM * value, int *length_ptr);
+void packet_get_bignum2(BIGNUM * value, int *length_ptr);
+char *packet_get_raw(int *length_ptr);
+char *packet_get_string(u_int *length_ptr);
+void packet_disconnect(const char *fmt,...) __attribute__((format(printf, 1, 2)));
+void packet_send_debug(const char *fmt,...) __attribute__((format(printf, 1, 2)));
+
+void packet_write_poll(void);
+void packet_write_wait(void);
+int packet_have_data_to_write(void);
+int packet_not_very_much_data_to_write(void);
+
+int packet_connection_is_on_socket(void);
+int packet_connection_is_ipv4(void);
+int packet_remaining(void);
+void packet_send_ignore(int);
+void packet_inject_ignore(int);
+
+void tty_make_modes(int, struct termios *);
+void tty_parse_modes(int, int *);
+
+extern int max_packet_size;
+int packet_set_maxsize(int);
+#define packet_get_maxsize() max_packet_size
#define packet_integrity_check(payload_len, expected_len, type) \
do { \
- int _p = (payload_len), _e = (expected_len); \
- if (_p != _e) { \
- log("Packet integrity error (%d != %d) at %s:%d", \
- _p, _e, __FILE__, __LINE__); \
- packet_disconnect("Packet integrity error. (%d)", (type)); \
- } \
+ int _p = (payload_len), _e = (expected_len); \
+ if (_p != _e) { \
+ log("Packet integrity error (%d != %d) at %s:%d", \
+ _p, _e, __FILE__, __LINE__); \
+ packet_disconnect("Packet integrity error. (%d)", (type)); \
+ } \
+} while (0)
+
+#define packet_done() \
+do { \
+ int _len = packet_remaining(); \
+ if (_len > 0) { \
+ log("Packet integrity error (%d bytes remaining) at %s:%d", \
+ _len ,__FILE__, __LINE__); \
+ packet_disconnect("Packet integrity error."); \
+ } \
} while (0)
-#endif /* PACKET_H */
+#endif /* PACKET_H */